6600 flashing codes ?

[AllanG70]

hiya folks

I have a Nokia 6600, that just opens with a white screen at present.

I have a UFS flasher, and tring to check correct code to flash it.

I have read the different threads here and just tried.... the following codes.

MCU = NHL103383.C1

PPU = NHL104091.20

I hit the flash button, and you can see results below....... any ideas please anyone???? preferably treat me as an idiot user lol, as only 4th phone have tried to repair, so far others worked fine but this one beating me.


1st Boot Ok, WD2, UPP: 0082
2nd Boot Error: 2
Platform: 6, Error Data:
C3 72 00 00 00 00 00 00 00 00 00 00 00 00 00 00
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
Process Failed, Repowering Mobile


please either leave replies here or email me at



thanks folks

Allan

[darx]

first of all you'r flashing different versions to the mcu and ppm this is the quickest way to kill you'r phone.
always use the same version for the mcu and ppm example


MCU NHL105530.C1
PPM NHL105530.34

TRY THAT CONFIGURATION AND DO A FACTORY RESET AFTER FLASHING

[sergo_zmeia]

And first format user area couple of times...
Good luck!
sergo_zmeia

[AllanG70]

thanks for the message, however, evertime I try to reformat user area.... it gives following message.

User Area Format Failed
00000000: 00 00 00 00 00 00 00 00 ........
User Area Format Failed
00000000: 00 00 00 00 00 00 00 00 ........

[electrophoretic]

flash ic faulty, you will be lucky if you can fix it after a reflow... DONT cook it too long just make sure its flowed... dunno if 6600 has 2 Flash ICs (User and System) but flow them both if there is two!!!

G

[Skater-Chris]

You cant format the user area if the phone doesnt intialise local mode. Flash the phone first. If afterwards it boots into local mode you can then do the user area format. Hope that helps.