problem with 6210 and 6130 - need help

[Doc]

Hi!

Has anybody experience similar problems like mine?

1. I have a 6210 here that connects to the network for a few seconds after switched on and the logs off again.
It has not been flashed or tampered in any way. It does not reset it does not say "contact Service" or whatever. Just log on and then off, stop.

2. The 6130 (a clone of the 6110 just for GSM1800 instead of GSM900) resets and does not connect to the network.
This happened WITHOUT any flash attempt! So i took the try and flashed it with a newer version (3.27C -> 5.00C) but the same effect. Does anybody have any clue? I did the FAID and all the checksums r ok...
If I keep on flashing wildly, is it possible to go back to the original state again (I have full backup also of e2p)?
This question is a general one. Did anybody killed a phone and restored a working backup already (including the e2p area).

Would be nice to hear of any report. Would let me sleep way better when doing trial and error research /n/images/smiles/icon_smile.gif

Doc

[DavieB]

The first is almost surely water damage - I have a 3310 here with exactly the same symptoms... It's no use /n/images/smiles/icon_frown.gif
If you find out how to fix it (opening it and drying it does nothing!) then please email me at [email protected] - cheers /n/images/smiles/icon_smile.gif

[Yasser]

Hi

I have a 3330 with water damage. It does exactly same thing. I tried drying it with hair dryer...nothing works...it gets signal for 10 secs and then no signal.

Well, use wintesla and try to do Rx Calibration....set to default.........between 920.0000000000000 and 960.0000000000......(i think)

Good Luck,

If you fix ur phone...tell use how u did it?

Take Care

BR

Yasser

[G marsh]

hi guys well when u first drop your phone in water never try to turn it on or u may short circuit it also try reflash the phone that may help if u tryed this then who nos

[Zzzooommm]

If it's a hardware problem, just change Power amplifier from the mobile and everything is ok!