6210 contact service

[jak2812]

hi i have one 6210 that when i switch on (always is no posible) apears contact service, i make the test with eprom tools and tells me mcu eprom interface test failed and eprom tune checksum test failed.
anybody have some idea? thanks

[James18]

View some thread that are already posted here, hope it will give some help to your problem.

[jak2812]

thankyou for your interest

[Romano1]

Try to flash it with mcu+ppm file update FAID etc. and see what happen.

[jak2812]

i had tried to flash with rolis but was imposible, no begin to flash, i have did it with cables that i use for flash with sw nokey10 for dct-3, with this software i can flash but with rolis not.
with this phone is imposible with any soft
is posible the problem are the cables ?
are not all the flash cables the same?
thanks a lot

[Romano1]

I don't know man, I use light Dejan flasher and Knok soft + M2BUS cable for updating with Eeprom tools and I never had problems with flashing ! :confused:

[jak2812]

ok thankyou