View Full Version : battery simulation
leorick
16-02-2003, 10:04 PM
I have problem while powering up nokia phone (3310/8210) using Lab Power Supply. I know it use about 3.6V but when I apply it to the unit, I can not turn it on. I believed it because of the other two center terminal (BSI & BTEMP). How do I simulate this battery to make it on? I already measure the voltage at the normal batt and here the result. (attachment) Anyone have the actual battery schematic?
<M457>
17-02-2003, 08:29 PM
look in a service manual... and you will understand!:D :D :)
bye
-=)(M457)(=-
leorick
20-02-2003, 08:41 PM
Thanks! But before I try this please advise me if I'm wrong.
in service manual, it says;
for BSI = Phone has 150kohm pullup resistor (that mean connect to +v side) and i must simulate 22kohm pulldown resistor (to the gnd).
for BTEMP = Phone has 100kohm pullup resistor and i must simulate 1kohm pulldown resistor to the gnd.
Am I right or I am right :D
dedekwien
21-02-2003, 10:06 AM
Hello Friends
Here you have Nokia Service batteries shematic
Enjoy
Regards
dedekwien
21-02-2003, 10:15 AM
Hello Friends
Here you have Nokia Service batteries shematic
Enjoy
Regards
dedekwien
21-02-2003, 10:24 AM
Hello Friends
Here you have Nokia Service batteries shematic
Enjoy
Regards
Powered by vBulletin® Version 4.2.0 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.