help with 3330

[mythnmagic]

Hi.
Can anyone help.I have got a 3330 which I was told worked but had been flashed.The phone turns on and the signal appears but then disappears after a few seconds.It comes back when you turn the phone off and on again.If you try to make a call it just beeps at you and says there is no network coverage.I have looked inside the phone and I think that it has been messed with.I have posted a picture if anyone can help me or tell me what needs doing would be much appreciated or if anyone can do it for me let me know!
Thankshttp://homepage.ntlworld.com/tanya.holder/P0000025.JPG

Any ideas please feel free to e-mail me

[email protected]

[paolo]

use noktool by rolis..you should have mbus or fbus cable..then press "update faid" and it will be ok

[mythnmagic]

Thanks for trying but I have already tried this but it did not help.
Anymore suggestions?

[paolo]

try to fullflash your phone..maybe a soltion and post the result...


If the signal strenght is full then a few seconds drop it is a hardware fault...

BUT

If the operator logo appear and it has no signal strengt bar..then it was only a software fault..
pls post the result ..

[mythnmagic]

HI
Have tried the flash,no good.
When you turn the phone on the signal is there not always full, and so is the operator logo but then they both disappear after a few seconds and do not return.Is the phone any good,can anything be replaced?

[paolo]

try reheating your PA , Antenna switch and Hagar..
If still no luck try to change your PA and antenna switch.