3310 help

[mexusbg]

I flashed a 3310 mobile. When i turned it on i recive "sim not accepted" - I reset SW locks, I Set Quick FAID, but it cannot connect to network. Somethimes when it restarts i get again :
"sim not accepted" (I must turn it off and thaN back on to worK).
How can i fix this shit?

[Nick_214]

Originally posted by mexusbg
I flashed a 3310 mobile. When i turned it on i recive "sim not accepted" - I reset SW locks, I Set Quick FAID, but it cannot connect to network. Somethimes when it restarts i get again :
"sim not accepted" (I must turn it off and thaN back on to worK).
How can i fix this shit?
did u try unlocking it?
Sometimes happen like that so you need to do is take out the SIM CARD and then put it back if you still get the same problem need to find a working full flash you can find it here in the forums just used the search button and flash it to your phone. After flashing change IMEI dont forget to update FAID when you change the IMEI.

[Edison]

I agree with that, find a working flash file and flash it to your phone and change the IMEI which you can find at the back of the phone. Usually setting the FAID solves the problem of lost signal, if not, your flash file has a problem.

[maxximus]

always remove sim card when flashing. try flashing it again with a working flash (reading someone else's working flash and saving it). use noktool to open locks and update faid. and try changing imei. hope this helps you.

[chunkhead]

Yep, the old "not getting network gag"!

Ok, when you use knok, also reset full factory settings as well! This will reset some setting with regards to how the phone sends and receives! And as for the phone unlocking, a lot of my unlocking attempts are stopped by this problem! But as you said, if you just restart them they work fine! After that I never have had a problem!!!

HOPE THIS HELPS!;)

[mexusbg]

It's not that. The stupid WIn98 was f***king the flash prosses.
I flashed it on WinXP - works fine.