8210 drains battery

[hexspoor2]

My 8210 can last only 24 hours after a full charge. After 24h the battery status shows one or two bars. I still have contact with my provider (o2). But when i try to make a call the phone beeps three times and goes back to standby. After 24h it's also impossible for other people to reach me.
Sometimes i get an "Insert simcard" message but this disappears after 5 seconds. Then i can use my phone again.

Regards,
Willem

[abu bayabas]

try to reflow or change ccont

[kingofcellular]

Sorry abu but its not that the problem is that the handset is hveing insert card problem to.Wash it with thiner n change the batrey connecter of handset n the problem will gone ok thx ;)

[terry]

abu just post his point of view

[kingofcellular]

I said sorry to abu n i just post my point of veiw thx ;)
[email protected]

[hexspoor2]

What exactly should i wash in thinnner? The PCB? I read in the nokia repair manual that a faulty ccont could cause both problems that i'm experiencing. Please advice

[kingofcellular]

wash the pcb of handset n then make it dry heat it from lamp or rework station n change the batery jack which is in the back case of ur phone where the batery terminal conect ok n ur right ccont is also damege n its also give the problem of insert card but this is not nesesery the ccont is proected with many part if ur cellphones power terminal r short or lickedge then the ccont is foulty if not then problem will gone like i said thx ;)
[email protected]

[mkwatis]

My 8210 which drains battery i used to change pa and it is ok till now:D

[kingofcellular]

Plz see the post again the cell phone is hveing insert card problem to if the doplexer is damage then wht about insert card ur problem is another but Hex problem is another thx ;)

[Andie]

@hexspoor2

for drains battery, try use another battery

for insert card problem - check simcard connector/clean pads and maybe need reflow or change the small square 5 pins near the simcard's pads on fones pcb.


good luck

[kingofcellular]

Ur talking about coupler 5 legs wich is midel in sim jack tips.Ok desold the coupler make it out from the pcb n dont put it back n then chek ur phone the phone will read the sim it doesnt goes to error insert card the coupler is for the safty of ccont ic ok.

This matter is making me crazy tell us hexpoor wht did u do to ur phone is that ur phone get perfect or not plz reply thx ;)