PDA

View Full Version : Anyone does nokia repairs???



boydonegood
13-04-2003, 12:34 PM
Hi all, Does anyone still do repairs on 9210? Phone doesnt power up at all,,,,"long story"!
Cheers terry

spaceimpact33
13-04-2003, 01:16 PM
hi,

i might bable to help you. could you please tell me what happend to your phone?

spaceimpact33;)

boydonegood
13-04-2003, 10:30 PM
Thanks for your time

Ive got a 9210 that worked fine but had a scruffy case,so i brought a
new case from ebay and attempted to fit it myself,all went well until
power up
The phone and "pda" powered up good for about 10 hours,then died.
I removed batt replaced and charged, The phone then powered up for
about an hour,then died.
the power up times slowly decreased until now does not power up at
all!!!
Have tried batt from my other 9210 and the unit still dont power up!
Any help would be great and obviously id pay for your time!
Cheers terry

spaceimpact33
14-04-2003, 07:03 AM
hi terry,

once you placed the phone together did you push the case just over the top of the messaging buttons to make sure that the conector made propper contact?

has that main cable that runs the key pad to the front panel of the phone got any damage?
if it dose you will have to replace it any atempt to repair it will lead to further damage.

i happen to have a 9210 that fell of a 3 story building onto a glass table and i have problems with that conector as well.
amazingly it still works but i get no coverage:rolleyes:

spaceimpact33;)

boydonegood
14-04-2003, 06:27 PM
Thanks for your ideas mate,but have double checked and all seems ok there!
Neither the phone or the "pda" power up,,,if the lead was damaged,would it just kill the pda part?

Thanks again for the thought though mate
Cheers Terry!!

spaceimpact33
15-04-2003, 09:35 AM
terry,

If the cable (qwerty flex module as named by nokia) was damaged it could mean that the front and the pda wont power up since the power to the front screen's
runs through it and the screen on the inside wont turn on and the same with the small screen.
the crack in my was so small but it disabled most features on my phone the screen went off and all the keys on front panel stoped working.

things you could check on your phone...
all screws are tight
all conectors are clean
all conectors make propper contact
clean all pcbs with alchole/metholated spirits and cotton buds
inspect qwerty flex module for any damage
you could check the 9210 service manule here is a link to the website that has it...
http://www.gsm-support.org/~gunman/

If this is not your problem you may have serious problems with the small pcb under the simcard/mmc area and this would be for nokia to repair:(

spaceimpact33