Help with 6210

[Giulio_UK]

Hi i was wondering if anybody can help me - i have tried unlocking a 6210
with Eeprom Tools - Resetted SP Lock, then updated Authority ID. Once this
was done the phone was unlocked to all networks, but when the phone
initially turns on it would find the network then lose it within a few
seconds. So then i tried flash unlocking it, and now it gets no network
coverage on any network. How can i rectify this problem?

Regards, Giulio

[newcasper]

try nokia tools 3.25 by jordik

[sergo_zmeia]

Hi!
Try to use nokia tool by rolis v1.9 or knok v2.2
Click set FAID then factory settings..You need Mbus cable..
If You dont have the schematic post and I'll send It for You
Good luck!
Post for results please..
Regards!

[Giulio_UK]

Where can i obtain this software? Would it be possible for you to send them to me? Thanks

Giulio

[sergo_zmeia]

Check download section....You will find them there...
Goodluck!
Regards!
Sergo_zmeia

[Giulio_UK]

I have just done what you told me to do with nokia tool (Rolis), but it is still not working? Could this be due to the fact that i tried to flash it? Any suggestions would be great, thanks for your help so far...

G

[sergo_zmeia]

Hi!
Try test Your nokia with Eeprom tools....Post the result perhaps it will give some poits where to start from...
Regards!
Sergo_zmeia

[Giulio_UK]

it says bad DSP Response,
Possible Reason:
-Faulty RF Part
-Missing Aerial
-Bad IMEI Data

Now does this DSP response need network reception? if it does then this will obviously fail cause the phone cannot get reception - this is the problem!!! can anybody figure out how to fix this phone!!!! thanx

[sergo_zmeia]

Hi!
May be your firmware is crshed..but Im not 100% sure...I had problem close to Yours with my nk3310....what i did..
Full flash MCU+PPM+virgin eeprom, update FAID, set original IMEI
update FAID again...Use knok with flasher cable..Hope this will help.
Regards!
SergoZmeia.