8210 No Access

[Massaf]

Hi

I've got a 8210 discharging battery.
I tried to change the PA several times, but it got 'No access'.
I returned its old Pa but it insists on 'No access'.
I tried to heat the Hagar, change the Cobba, short the antenna switch and the filters, but in vain.

What can I do with this 'No access'?


Thanks in advance

[rednec]

Did you correct the checksum (with NFree 1.3) and the FAID by using Eeprom Tools?

I've sometimes forgotten doing these actions with the consequence of "No Access".

greetz
rednec

[alcyahus]

still p.a.
change a new one dont overheat it while soldering..and ur problem will gone..about easily drain problem did u check ur battery 1st?