need help with this 3310

[boss1986]

hi

i flash this old 3310 but after it did'nt work.
iv reflashed it a few times with flashes from different sites (combined ppm/mcu's)

and at the end it says 'ok' but the phone still wont power on.

anyone know what im doing wrong?or what i need to do to make it work again.


cheerz

[sergo_zmeia]

Hi!
Read old posts You will learn alot things about flashing phones.
Did You set Faid?...Somewhere chunkhead post an algoritm about that.....Use Knok to set FAID
Regards!
Sergo_Zmeia!

[boss1986]

i can'nt set faid.

after i flashed it it wont turn on at all and all the software i have needs the phone to be on to set faid

[sergo_zmeia]

Try this site:www.id2.cz
You can download flash file from there..
Regards!
Sergo_Zmeia

[danwood76]

Try flashing a Virgin Eeprom!

Sometimes when you flash a phone with just the mcu+ppm then it will erase a bit of the Eeprom.

Make sure you change the IMEI back to the original if you get it working!

[Nokiacrazi]

When u flash it and need power use the charger instead it acts as a battery!;)

[boss1986]

thanks for the help guys,will try it now and let you know the results

cheerz

[boss1986]

still nothing.

flashed it with that virgin (did it very quick,quicker than it normaly does)
and after the power still shows no life,no leds or screen comesing on or sound.

any other ideas or anymore virgin eproms.

anyone know where to get seprate ppm and mcu files instead of the combined ones iv been useing?


cheerz

[boss1986]

up

[Nokiacrazi]

It did flash the EEPROM quicker because it is a smaller file! ;) Also here is a site where there a few separate MCU's + PPM's:

http://www.axnet.pl/ramki/ffn.htm

Good Luck! :)

[danwood76]

I will upload a full, working 3315 flash for you!
The only problem is I cannot upload on nokiafree, I keep getting a database error!

I will post the address of the file soon!

[boss1986]

thanks guys,finally managed to fix it but its still got getting any signal.
will have another mess with it later


cheerz

[Nokiacrazi]

If u get the same prob wid a different network try resetting FAID. If that don't work maybe it is a hardware problem.

Good Luck

[boss1986]

tryed a voda sim and an o2 sim in it and its the same :(

not had time to mess with it today but will tomozz and hopefully ill be able to fix it.

[cjard]

if it comes on but doesnt get a signal, use rolis479 or logomanager and an mbus cable to enable teh full R&D net monitor. now look at test number 01, and tell us what the screen says.

if a 3310 doesnt get signal, you usually have to quick set the faid (knok95), reset the SP locks, do a full factory reset, set imei back to original and quick set the faid again.

this can be very confusing for a phone that is on.. it might reset several times and still appear to be useless, so power off and plug a charger in instead. if you can see the battery bars growing, then the phone is listening to commands

[Nokiacrazi]

@Boss1986

I have found if you just update FAID it doesn't do anything. So I reflash it and then apply FAID and reset factory defaults.

[danwood76]

If you read the flash off the phone and Kill the FAID chksum you will not have to set it after you re-flash your phone, this will rule out the fact that the FAID needs setting!!

You can use G3n0lite to Kill FAID/MCU checksums!