SW Version 7.01

[rescu2000]

I have a 5125 with sw version 7.01 on it. I can't read anything. I have a fbus/mbus cable that is supposed to be switchable. I have never used it before, and there is no switch, So I assume it is software switchable. Anyway, I've tried several phones, and I can't read any of them with NokiaSoc2 or TDMA-Service-Full. The command Class.ini Files i have do not have 7.01, so i feel like this is the problem. I have looked and downloaded several files, but I can't find one with this version. Any help will be greatly appreciated. Also, can I test the cable? There are three pins connected in the nokia end, and I can Ohm it out to check the serial pin side if someone can tell me what serial pin aligns with which Nokia connector pin. Mainly I need the CommandClass.ini line for this software version, or an updayed commandclass.ini file.
Thanks
Rescu2000

[rescu2000]

Is there something that I have to do to the phone to get it to read? I'm at a loss here.
Thanks
Rescu2000

[rescu2000]

OH, and the message it gives me when I try to read is "Phone Not Responding".

[telecaster]

This command class will work with 5125 v7.01.
but it sounds like to me you got one of them cheap ebay cables.

[rescu2000]

Looks like the cable. GRRRR. What are the pin to pin connections and I'll ohm it out looking for a bad connection.
Thanks for the file also, I greatly appreciated it.
Rescu2000

[telecaster]

Originally posted by rescu2000
Looks like the cable. GRRRR. What are the pin to pin connections and I'll ohm it out looking for a bad connection.
Thanks for the file also, I greatly appreciated it.
Rescu2000

Cant help you there.
Install Logomanager and see if it detects the fone.

Where did you get the cable?

I got mine from UCABLES the NK-567.

[ismael_mj23]

Take connector out and verify how many wires are in there.

If it haves 3 wires, blue, whit and black, it is fbus and would not work with nokiasoc.

If it haves 4 wires, blue, white, black and red it is mbus autoswitchable then is either your pc or serial port configuration.


Don't matter really the colors, just be sure to have four wires or either 3 wires and a diode to pin 6.



ismael_mj23.

[rescu2000]

Well, I got screwed then. This is not switchable. It's got three wires. And I ohm'd them out and only ONE is connected. I'll just put my own serial connector on it, if I can find the schematic for the Fbus/Mbus switchable cable. Thanks Guys
Rescu2000

[telecaster]

Originally posted by rescu2000
Well, I got screwed then. This is not switchable. It's got three wires. And I ohm'd them out and only ONE is connected. I'll just put my own serial connector on it, if I can find the schematic for the Fbus/Mbus switchable cable. Thanks Guys
Rescu2000

If it makes you feel any better
I have seen 3 cables come from ebay that were trash...