Total Tool....

[Angelo]

I´m having a problem in putting this shit to work, sw detects the dongle ,give´s the serial number ,until now all ok but when i make read codes appears the messages "trying to turn on phone" and "triyng to enter test mode" and the progress bar keep´s moving until it reaches the end without doing anything.
I have tried with 3 different phones and result is always the same , i have programmed and assembled it according to Davor schemes and hex.
I have some doubts; where do pin 6 from the LPT(phone side) connects to the phone? (pin 1+3 in phone connector or it´s not connected??)
what fuses configuraion did you use and what is the config word and the checksum when you programmed the pic?
If you built it and if it´s working maybe you could give me a help....

thanks for your time

Angelos

[hergsm]

Hi

See http://nokiafree.org/forums/t30941/s.html

tested with me with TT 155

br

[hergsm]

for pin 6 of DB 25 i conected to pin 9+11 from phone

or this the cable

[Angelo]

when i say pin 1+3 i mean 9+11,i was counting for the other side but the result is the same :-(