8250 After Flashing Contact Service

[lesic]

I flashed an 8250 I was given after it had contact service and it fixed the problem. I used eeprom tools to correct faid etc and update imei and the sim card worked but it still crashes and reboots anyway. I have tried it a million times it still doesnt work. Is there a certain order of doing the faid and imei sp locks etc or is it a hardware problem?

[sergo_zmeia]

Try this : with Knok:
Quick set FAID, reset user interface, reset full factory setings, reset SP locks set new IMEI, use original IMEI, quick set FAID, in that order...
/thanks to chunkhead/
Regards!
Sergo_Zmeia

[chunkhead]

@ sergo_zmeia

:D

@lesic

For contact service:

1)Connect phone via Mbus cable, power on and run Eeprom Tools v4.0
2)Uncheck "DTR On" and click "Read Info" (Magnifying Glass)
3)Allow to read phone info, click "Test"
4) If fail tests regarding Cobba, phone has hardware fault!, If return PPM or MCU fail, goto step 5.
5) Open Nfader By Al, select file (*.fls), uncheck "Fade on" and "Fade Off" if you do not want fading leds, check "kill CS/FAID" and click apply!
6) Flash newly saved file to phone and update as above!
;)

[Sandy Boston]

Maybe try another eeprom. I flashed an 8210 and had tried a million different eeproms before I found one that worked. Someone else had a similar problem and a good eeprom fixed it.

[lesic]

Thanks Guys will have to try these out and get back to you. I broke my connector on the cable so I have to wait until I get another one.