after some sec signal loss

[teleiomenos]

i have a prob with a 3330 after some sec the signal is lost i flash it with last sw but the same problem what i have to do is hardware problem?

[Yotamz]

you have to update faid..

open Rolis Noktool (from the downloads section) and click the "FAID" button.

or open Knok, go to
Phone Settings > Quick Set Faid.

[chunkhead]

Please refer to the Forum FAQ! The Knok unlocking tutorial shows a procedure which should be used after EVERY flash! Learn this by heart!;)

[teleiomenos]

i faid but the same prob signal for some seconds and then lost

[sergo_zmeia]

Try a test with Eeprom tools 4.0...it will give You a point where to start...post results and Im sure someone will help You ..
Regards!
Sergo_Zmeia

[teleiomenos]

here are the results

mcu rom cheksum passed
mcu ram interface passed
mcu ram component not executed
mcu eeprom interface passed
mcu eeprom component not executed
rtc battery not executed
ccont interface passed
a/d converter not executed
sw reset not executed
power off not executed
security data passed
eeprom tune checksum passed
ppm checksum passed
mcu download dsp passed
dsp alive passed
cobba serial passed
coba parallel passed
eeprom sec checksum passed
ppm validity passed
warranty state passed
se version not executed

[SEDUSA]

i think you have an bad flash file , i think you need to flash again with virgin eeproom ,here´s the site go to sections eeprooms or fubu´s and download respective model and version . choise eeproom and flash it to phone if works say something , if makes the same try fubu´s this one works too , post something ok stay cool

http://www.nokia-flash.tk/


:D

[sergo_zmeia]

Yep!
Get a good flash it will do the job...remember always do a test this is our ears and eyes...regards!
Sergo_Zmeia