PDA

View Full Version : 8250 doesn't work with flash cable



Jope
09-07-2002, 08:03 AM
Hi!

I have a 8250 that won't work with knok or rolis.

When the engine asks me to press the power button, the phone powers up and the engine times out.

I have been using the same computer + cable (different tip) with 5110s and they work just fine. I also measured the 8200 tip and all signals seemed to be in the right places.. Anyone have a 100% correct pinout?

Any ideas?

Maybe I'll try tacking on some solder onto the end of the contacts in the tip, perhaps they aren't making proper contact.

Jope
21-08-2002, 04:14 PM
Still no ideas?

The cable tip makes contact, the pinout is correct ..

Flash type? Too long cable? Has anyone else had this problem?

bisdak
23-08-2002, 01:39 PM
defective connector to 82?

Jope
29-08-2002, 01:06 PM
Well, the correct signals go to the correct pins on the cable, and I can use LogoManager with the cable all right..

I'll try both fbus and mbus-modes again just to make sure.

krisis
30-08-2002, 09:33 AM
I also have this problem. the flash cable works fine with 8210, but not with 8250! have any idea about this?

krisis
30-08-2002, 09:55 AM
maybe cable is too long? my cable is about 1,20 m
how long is your Jope?
and can anyone who tried to flash 8250 tell how long is cable?

mrbig4545
04-09-2002, 05:47 PM
I have a real 8250 and it flashes perfect, the cable lenght isn't that long, bout 1m

NokiaPhreak
05-09-2002, 07:00 AM
try to clean your phone contact point, maybe it oxydize..

krisis
05-09-2002, 03:47 PM
but this cable works with logomanager in m/fbus mode!