Dct Imei Changer

[mcharami]

Hi i know you must have read about this topic a million times on this forum but has anyone out there actually chaged a UEM chip on any DCT4 phone and written a new IMEI via software??
If you have please say so as i will know then it is true and not a lie!!

[asoganm]

hi,

I have done it!!! It is very simple!!!
First U put flux on the chip!!!
Then U blow with a hotair station!!!
The chip will start 2 move on its own!!!
U then remove the chip!!!
The take a solder wick and flux and remover the solder of the board!!!
U the put flux on the board & chip & the use your hotair station to install the new chip!!!

[mcharami]

[QUOTE=asoganm]hi,

thats good what work station did u use and what type of software did u use to re-write the IMEI? What phone was it by the way??