3310 and 3330 weird probs

[piehole]

Hi, new to forum! I have a 3310 and a 3330;

3310: Will not switch on, cleaned for water damage and still nothing. Tried to flash eeprom to phone with both Rolis 4.79 and knok phoenix. Knok will only flash if the charger is connected when i am asked to power on the phone, it flashes ok but still doesnt turn on with power button. It did boot once with contact service after cleaning but that was it.

3330: Quite bad water damage but cleaned up well. Wont flash at all with knok but gets a response from rolis 4.79. The response is TX high, phone wont put TX low to start bootstrap etc, any thoughts??


Many thanks

[chunkhead]

How did you clean the PCB for water damage? Try my method: http://nokiafree.org/forums/t31337/s.html

[piehole]

Did that pretty much the same but with white spirit. What could be causing the TX high?

[chunkhead]

Try increasing the Delay Index to 5 in Rolis Flasher!?

[piehole]

Tried that aswell as cleaning them, got another with similar prob. 3330 wont turn on with switch. It charges normally with LCD working etc, I can flash to and from the phone OK when activated by charger. Is power button bad?

[chunkhead]

Try the Water Damage method on that first, then replace the switch if still bad!