regmwesiga
10-09-2003, 09:27 AM
Hi,
I have been finding the solution with no good result, I always remove contact service with the following tool, Knok ST Edition (full flash 3350 fls), Knok Phoeniz Build 1 a for 2100 3610,
after that I tested with Knok 2k3 Unlocker/Flasher by Knok, the result when I use this tool with M/Bus, I get MCU Dead, I dont know how to uplad the new one, I tried to upload with Rollis 4.79
on (Load MCU) is ok but on (Load PPM) it reply NHM-9 yet support ppm imeges.
Why MCU is OK but PPM is not support?
Where can I get PPM support this tool.
I have dejan 1.08,How can I plant the flasher loader and cfg into Windls 2.7, that I can laod MCU and PPM with no problem
I have been finding the solution with no good result, I always remove contact service with the following tool, Knok ST Edition (full flash 3350 fls), Knok Phoeniz Build 1 a for 2100 3610,
after that I tested with Knok 2k3 Unlocker/Flasher by Knok, the result when I use this tool with M/Bus, I get MCU Dead, I dont know how to uplad the new one, I tried to upload with Rollis 4.79
on (Load MCU) is ok but on (Load PPM) it reply NHM-9 yet support ppm imeges.
Why MCU is OK but PPM is not support?
Where can I get PPM support this tool.
I have dejan 1.08,How can I plant the flasher loader and cfg into Windls 2.7, that I can laod MCU and PPM with no problem