3210 Flashing Problem,

[jeffkow18]

hello :
i have download the file but now i am facing a big problem about flashing it in to my phone:(
i had use rolis 476(build 006) to flash it in to my phone but the was a error message come out :
FLASH ERASING ERROW ( BATTRRY VOLTAN TOO LOW)

then i use know22 to flash in to my phone and again error message come out :
------------------------------------------------------------------------------------
kNok - Engine build 22, Frontend build 18
Thanks goes out for the following:
Dejan, Kodo, Viper, Jozso (for hardware and cable support
and of course beta testing), Bph&Co, Saras, IceDragon,
Steina, Epilog, Invisible, Jethro, H-tom, AlAraf, Lead
and all the others who supports knok...
FLS1_ConfigurateBootstrapDCT3 : checksum is 4E8B
FLE5_DirectInitialiseBootstrapDCT3 : Press power on (if needed)
FLS1_GeneralSendBootstrapDCT3 : bootstrap seems to be running
FLS1_PreparePhone : detected NMP is NSE-8
FLS1_GeneralSendAlgoCodeDCT3 : checksum is BF8E
FLS1_GeneralSendAlgoCodeDCT3 : algo code seems to be running
FLS1_Write : written block (4 bytes) starting from 00200034
FLS1_Read : read block (256 bytes) starting from 00200000
FLS1_Write : written block (4 bytes) starting from 00200034
FLS1_Read : read block (256 bytes) starting from 002D7934
FLS1_Write : written block (4 bytes) starting from 00200034
FLS1_Read : read block (256 bytes) starting from 002B3928
-----------------------------------------------------------------------------------
what is the problem on it?
i am using window 98
P3 500 computer
i have no problem when i flashing all dct-3 phone expect 3210
I REALLY MAD ON IT,PLZ HELP ME

[wfc]

try having a fully charged battery and holding the flashing connector in while flashing. they sometimes make poor connection with the pcb:)

[jeffkow18]

but some of my GSM freind said that it is my processer problem because my processer running slow and not match with the flashing 3210,i am using P3 with speed 500,
it is true?:(

[fast_boy_slim]

i had a similar problem trying to flash a m8s 3210 on his PC with windows 98 with rolis 478b. Sometimes it started to flash and then crashed, other times i got an error saying check cable, voltage supply to low:confused: eventually i flashed it on my PC running in windows XP (with userport) and it worked with no problems. Personally i dont think the LTp port gives u enough power through the cable, or maybe the processor simply cant keep up:rolleyes: although i did manage to unlock it using a partial flash file, and it read the mcu+ppm no problems off the phone. I'd be interested to hear of a possible solution(even though it wont affect me)

[nikson]

try to increase the delay index of Lpt port. its under options then setup menu of the Rolis476 sw.

[fast_boy_slim]

Thanx 4 ur advice m8, i did try that and it didnt work:rolleyes: but as i said b4, i dont need to operate in 98, as it wasnt my computer; i use XP:D, thanx ur help:)