PDA

View Full Version : I need help for S40



bvuchev
27-08-2002, 12:30 PM
I have one dead Siemens s40, which can't be flashed, logged etc., but broblem is not hardware.
Somebody can help me ?

Regards
Boiko Vuchev

Sixth`SenSe
28-08-2002, 03:53 AM
try and result OK

Sixth`SenSe
28-08-2002, 03:55 AM
:D :grin: :D

Sixth`SenSe
28-08-2002, 04:03 AM
:D :p :D

bvuchev
28-08-2002, 08:07 AM
10x a lot Sixth`SenSe,
a have the same flasher but phone can't start flashing :(
Yesterday i just start flashing phone when communication stops and never start again. It is possible to write data directly to eeprom or someting to make phone boot... or someting else... i don't know...
battery is ok, cable is ok.

best regards
Boiko Vuchev

phonedudes
28-08-2002, 01:01 PM
Where did you get your flash files from and did you check them before flashing?

In our personal experience the success rate of using those PALLS40 progz as well as the s40flasher 1.01 on the s40 is very bad! Like 15%, every time we read it the flash was different. At that was even as low as 38400baud and using FACTORY OEM FLASHER CABLE w/external power.

The BEST and ONLY way to FLASH S40's or any of the others is with UNISIEMENS. Works 100% and allows you to just write the eeprom area and does it correctly, unlike the palls program.

Unfortunately we dont have a link to the Dongle Emulator version anymore as we have a hardware dongle, but Im sure you can find it somewhere.

Phonedudes :) :grin: :)

bvuchev
28-08-2002, 01:58 PM
Thanks guys !
I will try tomorrow and I hope that phone will be back to life again !

regards
Boiko Vuchev

bvuchev
29-08-2002, 09:12 AM
Many Thanks for all again !!!

Phone is wake up :))
but I need map file for it
There is phone info :
Siemens S40
PhoneID : 0E767900E338F5F9
IMEI : 350077-80-070594


regards
Boiko Vutchev