PDA

View Full Version : Nokia 6340i - Compatable DCT4 SPLock Software?



Dinjiin
17-04-2004, 01:43 AM
Hello All,

For the past few days, I have been trying in vain to remove the SPLock on my Nokia 6340i (North American GSM/TDMA "GAIT" phone).

I've been using an autoswitching FBUS/MBUS serial cable with various programs, and I've had marginal compatability at best:

DCT4 Test Mode will place the phone into test mode, but then aborts with the message "Can't find dongle!" after trying to 'Compute SP Data'.

FBus by Maestro (version 0.25) finds the phone, but prints out garbage when quering the phone (serial, IMEI, software revision, etc). It will successfully place the phone into LOCAL or TEST mode, and is able to run an audio beep test, but otherwise fails all other tasks. In all events, it prints out a little message at the bottom saying "Nokia 6310 only tested by me!". Strange, eh?

Noktools by Rolis (version 1.8 and 1.9) fails to find the phone in an autoscan, aborting with a "Check MBUS cable" message. I've recently been told that this program is DCT3 aware only, so I'm not suprised it fails.

JIC DCT4 Unlocker can set the phone into TEST mode, but it reads a different IMEI than on my phone's sticker (the last 7 IMEI digits mismatch, with the sticker reading ...2959913 and JIC-DCT4 querying ....5793269). Eventually it aborts an unlock with the message "SIMLOCK ERROR".

WinDCT4 (version 2.0) also fails to find the phone, aborting with a "Check Dongle" message.

Could anyone please point me in the right direction? The DCT4 code calculators failed me, and now the DCT4 dongle unlockers are failing me. If I have to, I'll send this phone back to Nokia for a reflash, but I have a feeling they are going to bend me over for the price.