sharp gx10 unlocking cable help

[wahee]

just got one from ebay there but some of the the wires are off in the com plug - a yellow. It was a mess
needless to say the cable dont work. anyone have a similar cable -who could do me a favour and have a looky inside the plug - a pic would be most appreciated.
__________________

heres the cable:
http://homepage.ntlworld.com/quad303/images/gx10.jpg

[Crux]

lolol. what an ugly cable.

anyway. can u post schematic of it?

[The iNSOMNIAc]

Just above the pink wire on the top towards the 9pin com connector should be a solder point. This is where your yellow wire goes to. so you should have pink then yellow then the comport connector.

I bought a cable simmilar so i could unlock a gx10 but it refused to work so i ripped the end off to use it with a moto191 cable (tx.rx.gnd) etc but can`t get that to work either.

can u take a snap of the sharp connector end so i can rebuild my cable again. TIA