LoMaster
15-09-2005, 09:33 PM
screen_saver.nrx
When entering power saving mode, the last animation frame is displayed in the background (behind the clock). Shouldn't that frame be cleared from the screen? It looks really ugly! Here are screenshots:
LEFT - a ScrSvr that I made just to try how it works (anim taken from Nokix samples).
RIGHT - a ready-made ScrSvr taken from Nokix samples.
Both screenshots were taken after the anim stopped and entered power save mode. The clock continues to run correctly, so the screen doesn't freeze completely.
vibra_controls.nrx
The vibra level is set to 0 by default, but vibra works correctly, and I can even change its power through vibra_power.nrx. When I try to increase vibra level through vibra_controls.nrx, the vibra motor spins constantly (even if I save the selected level and exit; the power is changed, though). Same problem with vibra_controls.nrx even when vibra_power.nrx wasn't present in the project.
netgraph.nrx
When the signal is very strong and the graph should be "above" the screen, it goes "below" the screen instead - just drows a line from the upper to the lower corner (and back when the signal drops down a bit). Sorry I can't provide a screenshot - there is no places with such a good receiption near my house.
--------------------------------
Nokia 3310 -> 3315 6.39(I) NOKIXed
When entering power saving mode, the last animation frame is displayed in the background (behind the clock). Shouldn't that frame be cleared from the screen? It looks really ugly! Here are screenshots:
LEFT - a ScrSvr that I made just to try how it works (anim taken from Nokix samples).
RIGHT - a ready-made ScrSvr taken from Nokix samples.
Both screenshots were taken after the anim stopped and entered power save mode. The clock continues to run correctly, so the screen doesn't freeze completely.
vibra_controls.nrx
The vibra level is set to 0 by default, but vibra works correctly, and I can even change its power through vibra_power.nrx. When I try to increase vibra level through vibra_controls.nrx, the vibra motor spins constantly (even if I save the selected level and exit; the power is changed, though). Same problem with vibra_controls.nrx even when vibra_power.nrx wasn't present in the project.
netgraph.nrx
When the signal is very strong and the graph should be "above" the screen, it goes "below" the screen instead - just drows a line from the upper to the lower corner (and back when the signal drops down a bit). Sorry I can't provide a screenshot - there is no places with such a good receiption near my house.
--------------------------------
Nokia 3310 -> 3315 6.39(I) NOKIXed