Need help for UFS3

[mehrankh]

I have a cloned UFS3 box with HWK that was working with ufs suite 3.03.
I used a software to upgrade to 2.6.7 and after that the DCTx sayes BOX_AUTH_ERROR and others saying "Selected Device, not Compatible with Software".
I tried every firmware that I could find and also reverted to 2.5 and used "UFS3 Tools 2.69b" but results are same.
Seems they are working only for original boxes.
with DCTx Tools 1.3j when I push connect it only beeps after checking the box and shows nothing.

I checked other boxes atmega on the box(with changing the ft232's serial)it's working.so it's the firmware problem inside atmega.

With "HWK Replacer V 3.03.001" "

Updating started...
> Device: UFS3 SarasSoft, S/N: 71*** - opened.
> Entered to BOOT... >>> 62 CF
> Features: 00000001
> Section 1F: 00C7
> SN = 71*** (0x11***)
> UFS fw CRC: 0x5FA6401A
> Please update your...
> Operation aborted
> Device closed. and says

You need update your UFS before to continue
You can see this message only if:
- Checksum of your UFS firmware is not correct
- UFS firmware was patched
- Very Old firmware
- ...(i am very lazy to make more tests)

PS: you can use UFS3Tool to update your boxAny HELP,
Thanks in advance.

[Skater-Chris]

I think you may have broken your clone box. Using original firmware upgrade tools on a clone box can kill it or mess it up. I would suggest looking for a clone UFS3 firmware updater.

[mehrankh]

If you know where plz let me know.
I searched many where and many times.