Jas1
25-11-2002, 12:25 AM
Ive got an 8210 converted to an 8250, modded flash all good.
The problem it has was there before flashing, the phone works perfectly 90% of the time but sometimes it looses signal totaly untill i reset it *3370# (quickest way). Then its fine again, Ive cleaned the antenna conections, which made it slighty better but it still drops out. I read about using a hair dryer for 20 mins on top of pcb, has anyone tried this? any tips tricks which could help?
I dont want to damage my phone by over heating it.
Any advice would be gr8
thanx in advance
Jas1:rolleyes:
The problem it has was there before flashing, the phone works perfectly 90% of the time but sometimes it looses signal totaly untill i reset it *3370# (quickest way). Then its fine again, Ive cleaned the antenna conections, which made it slighty better but it still drops out. I read about using a hair dryer for 20 mins on top of pcb, has anyone tried this? any tips tricks which could help?
I dont want to damage my phone by over heating it.
Any advice would be gr8
thanx in advance
Jas1:rolleyes: