I allready fu. ked 3 nokia 3210 while flashing with Dejan flasher 1.04. Symtoms after the flash was erased and start writing the new flash at 1% it stops and gave me a message CMD error. Anyone know what it means? What can i do?
Printable View
I allready fu. ked 3 nokia 3210 while flashing with Dejan flasher 1.04. Symtoms after the flash was erased and start writing the new flash at 1% it stops and gave me a message CMD error. Anyone know what it means? What can i do?
Again, try to load with a full working 3210 flash file
Please sugest me any place where I can find a full working 3210 flash file.
Are you also using VPP in connector??? without VPP you can't flash 3210.
I think it,s a connectors fault. Anyway thank you, but what is a VPP.
VPP - programming voltage pin
Phones up
connector:
1 - BTemp
2 - FBUS Tx
3 - GND
4 - MBUS
5 - FBUS Rx
6 - VPP - must be connected to +5V to flash 3210
I'll let you know on monday. Do you want to know a trick about A300, A400, A100 with falce full net bar and all calls failed?
Thank you Al.