5210 v 5.25 fls

hi, ive downloaded the new 5.25 mcu & ppm fls from the link on the forum, but am having trouble flashing it to my phone.

im useing knok phoenix software to flash.

problem is: when it comes to the part that says"turn on phone", i press the power switch and the software starts to write the mcu file but stops after a few seconds, but gives no error... just stops.

please help

lolly

Knok did that with my 5210 one time or two but try again it will work fine...if you are using winxp don't forget using userport program and check in your bios that your LPT port is set to ECP..
Hope that helps

Shut-down all other progs, did happen to me too.