No Network & Restarting After Flashing 3315...

[kOuBy2k1]

I was used:

-> Rolis DCT3 Flasher v4.78 BUILD6
-> Nokia Tool by Rolis v1.8
-> Koci Nokia Logger v1.81
-> FAID Monster
-> Knok BUILD 22

I was done:


-> Flash the MCU with NokiaFree.org's file for 3315 (v5.57) at 00200000.

-> Flash the PPM with a perso PPM (new ringtones + PACK B + with update of all PPM CRCs) at 00340000 adress.

-> Flash the EEPROM with a virgin EEPROM at 003D0000 adress.

-> Restore phone's original IMEI with Nokia Tool

-> Use Koci for read the MsID

-> Use MsID in FAID Monster for calculate FAID

at this time, I see Sec. Code: Failed in Nokia Tool...

-> Use Knok for reset full factory settings. (with no SIM insert in phone)

-> Use Nokia Tools for update FAID.

And after that... no network and restarting after 20sec... hardcore...

You can look my image's attachment...

When I'm power on the phone, I going in the menu and I see operator menu... these infos are in the SIM card??? because I was flashed all the RAM???

THANKS IN ADVANCE...


kOuB.

P.S. Sorry for my english... I'm french.... LoL

[NokDoc]

Ai,

U choose a bit of the wrong way.
First of all, Eeprom is definately not required.

Then U should have paste the mcu and the ppm to one file, called full flash.

That full flash U should open in ppm manager to recalc the flash checksum.

Then U could flash it, and easily update faid.

U can still retry this, but now U need to repair the imei etc, just like U told after flashing and before faid.

If U not have the extra 3315 menus, U can now set bit 30 of the phones profile in eg pclocals.

Good Luck

NokDoc

[Jas1]

I have been editing some flash files recently, half the time they just wont work. I`ve had enter pin number then keypad locks, wont unlock, contact service and just a blank screen. Is there any soft sure to make a working editted flash?
thank u
jas

[kOuBy2k1]

it's works fine now !!!

THANKS AGAIN...


@Jay007 -> try PPM Edit... in in the forum, Section:Software's Posts...