flashing with kNok 22

[lostblur]

When i selected READ ALL (mcu, ppm, pmm, eeprom) of a phone it created a set of several files for each of the packs.

Now i am trying to WRITE mcu and ppm, but kNok only seems to let me select the files one by one which is very tedious since i have to unplug the phone from the power cable and the flasher cable each time for the flasher software to detect the phone.

is there a short cut? is it possible to select several files to be written and the let kNok run through them all/several at once?

thanks for your time

[maddog17]

why dont you read fullflash then you can get extracting programs i dont know which ones but you can extract like the eeprom try that and tell me how everythings going k

[lostblur]

i can do full flashes easily. but i dont want to copy the EEPROM area, not the PMM, i just want the program to read the MCU and PPM and leave the as two seperate files. or atleast a way to selecet all when writing.

[Shidoshi]

Hmm...

Select another program to Read/Write the Flash with if that is the problem

Cheers,
-Dave

[lostblur]

can you recommend a program? i went through quite a few before i settled with knok...

throw me some names please

[Shidoshi]

Hmm...

For example Nokia Tool by Rolis v4.77 (Check the download section)

You can read MCU+PPM or you can read the MCU then read the PPM as 2 seperate file.

The addresses for each can be found in the Newbie forum, check on of man0n's posts, it contains a table with these addresses

Cheers,
-Dave