Hello once again
I came across an idea: Is it possible, to get a LED at the power switch of a 6610/7250? I mean, if i run some wire from one of the display's LED's to there and put in another LED of the same type (because they are small enough to find a place there), will the specific display LED still be same bright? Or do i need to use power from another place on the PCB, such as the "common" power tracks for a group of LED's (they are grouped, aren't they in these models? I know only of other models where the display- and keypad LED's are grouped).
The reason for this thread is, specially on the 7250, it is almost impossible to get it turned off in darkness because the button is small and hard to press, when the keylock kicks in fast (10 seconds here) it's a nightmare to get that phone off. A light would here be extremely helpfull
Thank you for some advice.....
Thanh