Why can't I use m/fbus cable in my 8210?

[pekde]

Hello?

I've been using m/fbus cables in 5110, 6110, and 3210 in my PC.
Now I bought that to 8210. But I can't get it to work.
I've managed to use flasher cable though to the same 8210 and it works. The m/fbus cable should work becouse it is new, i've tried also another m/fbus cable but it doesn't work either.
Even logomanager doesn't recognize it, whether i put it from the program to f or mbus cable.

I think that i can put cable to the 8210 to the right way. There is 4 pins in the thing and 2 screws, they're propably ment to fit to the holes in the 8210. But if the flasher cable with 3 pins works, why these 2 cables don't. Can't I possibly put it right way?
I keep trying it though. But i've tried to put little power to cable head without result. ???????

Happy easter to everybody!

[danwood76]

Keep moving the cable about until the screws fall into the holes, I had the same problem with mine!

If this doesn't work push it over to the left side as this always works with mine!

[pekde]

I tried to move it up an d down to the left and right, and push very much. Doesn't help.

I removed the 2 screws and tried without them so that i can be sure it is in the bottom. No help.

Now maybe I have to try the cables with another 8210, if mine doesn't accept mbus cables? I have version 5.26 by now.

[danwood76]

If you can flash with the same phone then the phone accepts Mbus!

You should try it on another 8210, if it doesn't work on that talk to the person who sold you the cable!

The cable may be faulty and you might need to send it back!

[pekde]

Yes, I will do that.

If I can find somewhere another 8210.
Very few people have nowadays that phone.