3330 Knok Problems

[tiny1000]

While using knok95 - Reset SP Lock/ Quick set faid and a few other commands I get the following error messages:-MBUS_SecurityCommand : cannot execute. Can anyone throw any light on this one

[ZNOD]

You have to configure KNOK where your MBUS cable is connected (either COM1 or COM2) when flashing your phone and using the READ, WRITE and ERASE option, use your flasher cable (connected to LPT port either 1 or 2) and when using the CHECK AND FIX, PHONE SETTINGS (where you update the FAID of your phone), and MODIFY LOCKS, use your MBUS cable (data cable).

[tiny1000]

Thanks Znod - done that, now i get this when I try to 'quick set faid' :-MBUS_SecurityCommand : cannot execute 'Enable extended commands'
CMD_handlecommands : cannot analyze phone
MBUS_SecurityCommand : cannot execute 'Enable extended commands'

[Svangsta]

when you do that, make sure that your'e phone is off. Just connect the phone to the cable, press on and then do the command like reset sp locks. Then it will work. Good luck,

Greetings Svangsta

[sergo_zmeia]

Phone must be on when You use Knok and Mbus cable....if You receive cannot analize phone : remove the battery put it back turn on phone and try again...be sure thaat you have chosen the proper model from the drop down menu..
Regards!
Sergo_Zmeia

[chunkhead]

I have written a guide for this in the Forum FAQ! Have a look!