dead 6210

**mch_svk** · 26-09-2002, 08:34 PM

Hi....
I have N6210 with bad signal (goes down after a few seconds)
I tried to flash it (update FAID, IMEI and SP) but doesnt help so i tried to flash it with 6250 and still nothing...
So I wanted to put it back to 6210, but I forgot to use full flash (with eeprom too) so MCU+PPM from 6210 and EEPROM form 6250 was in the phone so it goes CONTACT SERVICE.
I turned it off to flash it with good one, but the phone is dead. I cant turn it back on and its imposible to flash it (no response)....
Could anybody help me.....plz.....
MCH

**inflexion** · 26-09-2002, 10:11 PM

try reflashing again but when it says power on use the charge sometimes works for me.

**mch_svk** · 26-09-2002, 11:28 PM

thanks.... it flashes again....
MCH

**mch_svk** · 27-09-2002, 12:51 AM

and could anybody help me with "no acces"
phone can find networks, but cant acces any...
i tried to change the imei but doesnt help it...

MCH

**madmania** · 30-09-2002, 09:26 AM

I think your phone has faulty hardware. the signal reception or transmitter is controlled by PA (power Amplifier) IC. Try change this IC.
By the way you can test your phone using EEprom Tools. select test mode. then let the software do the job

**mch_svk** · 03-10-2002, 11:09 AM

eeprom tool says :
Bad IMEI Data
Faulty RF Part
Missing Ariel

so it looks it will be the RF IC but I'm not sure about the location of the chip....
could u pleas locate it on the picture....
thanks

**thanasis** · 03-10-2002, 01:33 PM

try to put the original IMEI of your phone.

**mch_svk** · 03-10-2002, 04:31 PM

I just tried to put other IMEI, but there was still the original, so it is not the IMEI problem.... only if the PCB was changed before I get the phone in my hands....

thanks

MCH

**madmania** · 03-10-2002, 05:49 PM

As I said it's maybe faulty hardware. The eeproms tool say
bad i-mei ... then you say the i-mei is ok (we can get rid of this)
faulty RF part ..... the solution is only change the faulty part

from the picture the IC is on the head of the phone there is 2 ic on the center. try to change the ic. (wich one ?? I don't know either, because both of them responsible for the signal)

missing arriel....hmmmm who know about missing ariel???

because I don't know about this part hehehe sorry

But sometimes, try to flash again the phone with "work" full firmware. If this can't help either so the problem is on your hardware not the software

If you don't have the full firmware, just tell me. I have the file..

regards...................