I bought a 8250 which had 8210 mcu in it (for DK T9 dict etc.), then tried flashing with Rolis to 8250 v3.18 flash.
Now it says Contact Service, always.
Only flashed mcu/ppm area though, not eeprom (3d0000-400000), could this be the problem (maybe I needed to flash a virgin 8250 eeprom there)?
When I try reflashing with original mcu/ppm, Rolis always says 'Phone RAM bad', Dejan says something similar.
Using Eeprom Tools on mbus, it can't read IMEI/security code etc., as if it can't contact the eeprom. Trying to change IMEI doesn't work either.
Is there anyway to save this one with just a flasher-dejan or mbus cable?
Got WinTesla working now, it says:
4. MCU EEPROM Interface.... Failed
5. MCU EEPROM Contents.... Not valid
C. EEPROM Tune Checksum.... Failed
Everything else says Passed, though.
Tried fixing FAID too, no help.
Bookmarks