phone light stays on

[BIG_wOrm]

Why does it always happen to me AGH <br />
Well heres problem i was sitting there texting a mate and drinking my cola when silly me decided to drop my 3310 into a glass of coke!!!<br />
<br />
At first if i pressed say 1 it would jump to the games menu or something like that but that sorted it self out after a few hours and a while under a hair dryer...<br />
<br />
..BUT then that night a relised that the light stayed on ever so slightly i could av coped with that but it is getting a real pain to charge my phone every 5hours or so. Can any please help me or am i doomed (well at least av to fork out for a new one) <br />
<br />
PS-- I read the phone with knok 22 and here are the results:

[BIG_wOrm]

SECURITY PHONE INFO by KNOK (build 22)

Software version: V 04.19
03-01-01
NHM-5
(c) NMP.
Product code: 0505519
Language pack: B
Profile: 23 00 90 10
MSID: 00000000000000101000000000
>>> MSID is invalid <<<
MCU checksum: 9E54
ASIC: G-01
COBBA: =31
DSP internal sw: 6
DSP external sw: B60.6.755
03-Jan-01
NHM-5
(c) NMP.
Security code: 66542
Simlock info:
Simlock 1 is a user lock and it's open (00000)
Simlock 2 is a factory lock and it's open (0000)
Simlock 3 is a factory lock and it's open (0010)
Simlock 4 is a factory lock and it's open (00000003D0)
Order number: ???????
Manufacture month: 0301
Purchase date: 1235

[-tek-]

hi,

well, try to open the phone and clean the pcb and all the parts doing contact on the pcb...if that doesn't help, well...you messed up your phone...

greets,
-tek-

[Kid]

Your MSID is missing, you need to full flash it.
clean the PCB b4 flashing. as 4 the lights on problem, short of the LEDs to the ground. Should be ok after you clean your PCB.

[k-ni]

hi!
your software system is ok, but your hardware got a bit of problem.try to calibrate two little capacitors near the heatsink just next to an IC which control the keypad, change it...thats it....and go clean it 1st.

[Kjetil]

Hi all.
It is correct that the pcp has to be cleand.
Had the same problem myselfe.
Most important is to clean on the holes witch the led are mounted in. I cleaned the board a couple of times with no result. Afer using a stiff paint brush with isopropanol in the holes it worked.

[Kenny Lee]

There's a solution because of the Keypad/Vibrator/Buzzer control IC at the low end right sides seem open joint try to resolder the IC Joint.
The IC Coding is NMP70433 (20 joint)