3310 turn off problem

[bernardo]

hi i have an 3310 v4.45 it turns of when caling and the batery bar is below tri bars,its not batery problem because when you turn it back it works for days.when the batery is full bar there is no problem.
someone please help.

[Andrei]

hi i have an 3310 v4.45 it turns of when caling and the batery bar is below tri bars,its not batery problem because when you turn it back it works for days.when the batery is full bar there is no problem.

This COBBA or CCONT problem.. maybe...

[wesam]

hi
first you must chang your battry
if not then chang battry connector
if not work then you must chang the pa
goodluck
wesam

[bernardo]

thanks for help i will try the batery and the batery conector.
but i think is hardware problem in electronics.
thanks.

[Janus]

It seems to be a hardware prolem,if your phne turns off only when u make or receive a call,probably PA takes too much current,try to change it,or is a manufacturer problem wich you can repair with some indications.I will put them here(confidential indications for NMP service centers)very soon!Promise!

[bernardo]

thanks janus for help.i will try to change the pa.

[markchee]

Mr bernardo,whats wrong with the 8210 which drains out the power very fast,less than 24hrs for standing by?Please advice,thank you


Mark
____________________________________________
Sometimes you get help,sometimes you don't,so be patient

[FaithNoMORE]

Hey Bernardo I have the same problem with my 3330...check this files...there's solution!!!

[bernardo]

hi i figured it out it was the batery after all.it worked for days but not when i made a call.
for 8210 which drains batery i woud say its a dead chip try to measure + - on the telephon and compare to god one.whit an ohm meter.if its to low in one direction try to change or remove ics whit hot air solder to find fault.