3310 Mbus/Fbus Problem ?

[PcDoc]

Hi,

After flashing (full) a 3310 with 5.57c, (from 4.0 when I connect Mbus/Fbus cable, phone either resets, asks for SIM, no screen, any combination of all above.
Otherwise works FINE !!

Ideas ????????????

[mexusbg]

You must connect the M bus cable, turn on the phone (or plug in the charger), don't enter pin, open Knok phoenix from the menu "Phone settings" select "Quick set Faid", then from menu "Modify Locks", select "Reset SW locks", then "Qucik set FAID again.

[PcDoc]

Thanks for quick reply, Just did all that still does not work !!

I soon as I connect cable to edit stuff (LM) phone shuts down !!

Otherwise works FINE

[chunkhead]

Sounds like a short on the PCB! Open the phone and clean the contacts where the cable connects, also clean anywhere else you feel neccessary!