Cannot flash 6210

[XARiUS]

Hi ppl!
I am trying to fix a nokia 6210 contact service!
I was able to read flash from it, then i analysed it, and found that first eeprom checksum was bad! So i corrected it...
Now, when i try to send flash to phone, i'm unable to do it!
I previously was able to write mcu+ppm to it, but when i tried to write the eeprom back to it, the phone wouldn't start to flash!
What can be wrong with it??
Can somebody help....

Thanks...

[Iccang]

Hi Xarius...

Try to full flash with eeprom zone in one way (but U must have a full flash file from another phone), don't flash mcu+ppm and flash again the eeprom only coz the virgin eeprom flash file of 6210 at the net is bad.
The next is U must change ur imei, recalc FAID, etc...

BR,
Iccang
========

[Abe]

Use this 100% working eeprom+pmm file.start adress 5A0000
Afetr that change IMEI,restart phone manually and then Calculate faid...........thats all...................

[XARiUS]

I'm starting to becoming very frustated!! Now, when i put inside it it's original flash, it don't turn on! When i press the on/off button, it blinks the leds for a short time! I was forced to open the 6210 to flash it! Lol! He now, only flashes when it's open, and when i force the battery a little! Cound it be an hardware problem??

[XARiUS]

Now, i've re-assembled it, and tried to flash!
Knok22 said this:

misc_calibrate_delay: 199.47 BogoMIPS
FLS1_GetFlashParameters: parameters found NPE-3(6210) - DCT3BT2.TIA
FLS1_PreparePhone: found flashing params NPE-3(0) - 61, 07
FLS1_ConfigureBootstrapDTC3: Checksum 4E8B
FLE5_DirectInitializeBootstrapDCT3: Press power on (if needed)
<Now i press power on>
FLE5_DirectInitializeBootstrapDCT3: executing bootstrap
FLE5_DirectInitializeBootstrapDCT3: preparing reading phone ram
Cannot prepare phone

(
Why???
Anyone... Help please!!!