8210

[mundenhouse]

after flashing 8210 with rolis 4.77 i switch to eprom tools to update faid etc phone not recognised not connected any ideas the phone was switch on cheers any help gratefully appreciated

[chunkhead]

The 8210 attachment is crap!!! Hold the unit firmly against the phone or tighten the two screws so they are lower! Use Knok to update faid!

[mundenhouse]

thanks ive tried that still no joy m lead works ok with logomanager im using 2000 would that causes any probs
just refuses to see a phone connected im getting desperate could it be com1 settings in 2000 thanks

[chunkhead]

Did you set the com port to 1 in Knok? I'm running a dual system Win98\2000, Knok will not work 100% in 2000 for me, only '98! That's prob the cause!!!

[danwood76]

I have a similar problem!
I have two 8210's, my cable works in one but not the other!

I have slightly solved this by modding my flasher cable so it doubles as a data cable by connecting the M/bus terminals and ground terminals together by use of temporary wire!
Would post pics I you wanna see them!

[kipper9999]

post the pics for me please m8. I have an 8210, and a flasher set of cables for all old nokia's. 3310 8210 etc.

Any diy mod to make them data cables aswel is appreciated


Ant

[danwood76]

I shall post pics of the inside and outside when I get home!
Im havin problems with Internet explorer and it wont let me reinstall it, at the mo I am at work on their PCs!
As soon as I get it goin again I will post em!

So your flasher works correctly with ure phone??
And the cable works on logomanager, have you got it set to mbus on logomanager or fbus??

[danwood76]

Here are the photos of my cable bodge!
When you do it make sure you connect up the right leads (mbus-mbus and ground-ground)
I have also included the pinouts for the 8210 which should help you if you cant work out the photos!

I have done this to all of my cables so that I didn't have to buy a data cable kit or a cable for each type of phone!

Hope it helps!