Flasher cable question

[NokiaFlashUser]

I was wondering this schematic i was thinking of making is it possible to make it without putting it on a board sorry for the stupid questions!!

The 1 i bought from tele-west worked once and packed in dead as a dodo, it was pretty cheap quality only payed a fiver so not really lost out.

Cheers in advance

[danwood76]

You could put it onto strip board,
It is easier than PCB and a lot better than just wires
Basically its a circuit board with lots of regular holes on it with copper tracks running all the way along in one directing

To break tracks just use a drill bit of an adequate size

regards,
Danny

[NokiaFlashUser]

Where do i solder the ground points to this has been really bugging me as im making 1 tomorrow maplins has all the parts for 75p LOL

Thanx

[danwood76]

All ground points go to pin 25 on LTP
Yes the parts are very cheap

regards,
Danny