I have an Service Manuals without Component Layout.
The accu and the charger is good...
If I charge the phone, the measured transmitted supply is 0.2 V in accu-pinout... The charger LED do not work...
Tnx 4 helps
I have an Service Manuals without Component Layout.
The accu and the charger is good...
If I charge the phone, the measured transmitted supply is 0.2 V in accu-pinout... The charger LED do not work...
Tnx 4 helps
if you use not original charger will not work.sometimes if the battery not full empty can not start to charging.if everything is ok
try to reflash it.
I cannot reflash the phone.... I could cry... The phone working 100% but not charge. (Not water damaged)
anyone: have a Component Layout?
Tnx for Hints:
byez
Charging voltage must be <=5 volt's.
Last edited by Sergey_79; 19-12-2002 at 11:05 PM.
Yes. I know, but too smal the 0.2 V charger supply...
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks