Results 1 to 4 of 4

Thread: hot air rework station defect

  1. #1
    Join Date
    Nov 2002
    Location
    Philippines
    Posts
    133

    Angry hot air rework station defect

    hey there!

    my ordinary Aeolus 850 rework station (made in china) is malfunctioning.

    recently, it always turns the air flow off itself after just over a minute everytime i'm using it.

    can anyone have some insight on the matter?

    are there available parts for these?

  2. #2
    Join Date
    Nov 2002
    Location
    uk
    Posts
    128
    Thermal cut off???

  3. #3
    Join Date
    Nov 2002
    Location
    Philippines
    Posts
    133
    i don't know if that's the term for it - thermal cutoff.

    what's always happening is that when i switch it on the air flow is good. the heat is turning on and off. after just over a minute or so the air flow turns off and doesn't turn on again.

    i think it happens when the filament is already hot.

    any insight?

  4. #4
    hi,

    there is a thermal inside the filament, you can try to move it bit away from the filament perhaps 1 cm and if still doesnt work then the thermal is damaged and you might need to replace the filament or just the thermal ( i dont know if i they selling the thermal only ).

    when the filament is cutoff the led on heater will blink fast.


    hope this can help

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •