accept(phone TX= High)

[mohhag]

I tried to flashing of two 3110.
One of them is ok.But I took error for another mobil just on rolis: unknown flash type. Flash ID:20600850
wait for boot counter accept(phone TX= High)

On knok error:
FLE5_DirectInitialiseBootstrapDCT3 : Press power on (if needed)
FLE5_DirectInitialiseBootstrapDCT3 : executing bootstrap
FLE5_DirectInitialiseBootstrapDCT3 : preparing reading phone RAM
FLE5_DirectInitialiseBootstrapDCT3 : executing reading phone RAM
FLS1_GeneralSendBootstrapDCT3 : bootstrap seems to be running
FLS1_PreparePhone : invalid NMP returned in phone RAM
FLS1_PreparePhone : detected NMP is NHM-5
FLS1_GetFlashParameters : parameters found NHM-5(3310) - DCT3BT2.TIA
FLS1_PreparePhone : checking alias
Cannot prepare phone

Phone seems is dead

Tips thanks
mohhag

[paolo]

try using rolis flasher 4.78b6..

[mohhag]

I'm using this version of rolis.
Mohhag

[Al]

try in Rolis: Options->Setup->Other->LPT setup->Delay index->higher value
if it not helps seems to be bad flash IC (coz wrong flash ID)

[mohhag]

No!!!!!!
Same error
What can I do about wrong flash ID?
Regards mohhag

[Al]

it's a hardware bug try to reflow/replace flash IC