Results 1 to 7 of 7

Thread: Help unlocking 688 gsm Ericsson

  1. #1

    Help unlocking 688 gsm Ericsson

    Anyone know what I am doing wrong? I tried multiple programs including Saras workshop 1.7 but no luck. I am using an OEM data cable but it will not detect the phone.

    I connect the phone cables with the phone powered off
    I then click no in the workshop
    I hold donw the NO key for a second and the phone powers up
    10 seconds later I get an error saying "timeout no responce from phone"


    Thanks in advance

  2. #2
    Join Date
    Feb 2003
    Location
    Hungary
    Posts
    15

    ci.com!

    Dear ci.com!

    I send to you an ericsson service software and cable pinout!
    It's work at me, but it wil not work at you, than chek your cable!!
    Watch on pinout! Bind the 7-8-12 pin on sort! This way worked at me!

    Good luck!
    Best regards

    Luises

  3. #3
    Join Date
    Feb 2003
    Location
    Hungary
    Posts
    15

    one more

    Hi again!

    Maybe you have a data cable,but unlocking programs work only
    service cable (data cable have:Rx,Tx and GND, but service cable have: Rx, Tx, GND and shorts/-7-8-12/)


    Sorry my wrong english!!!
    I hope it's help to you!
    Best R.

    Luises

  4. #4
    I figured it out. I put an FBUS/MBUS switch between pin 7 and 12 on the OEM cable.


    Thanks for the help

  5. #5
    Join Date
    Feb 2003
    Location
    Hungary
    Posts
    15

    Lightbulb Hi!

    I had got an er. 688 so I had the same problem!
    It was wery hardly to open the locks.
    First times it said "tampered",-this time alredy working.
    On the cable the pin 7 is test, the pin 12 is +5 volt,-that's ok.
    The pin 8 is +5 volt on the another ericsson mobiles( T10,T18 etc).
    So you need to connect together each three test pin 7-8-12!!!
    Try it pls and reply me!
    Have you got any 688 flash and eeprom?
    Maybe will to need for you respectively for your 688.
    If need to you I have one just ask me!

    best regards
    Luises

  6. #6
    Luises,


    If you are using an original Ericsson cable all you need to do is solder a connection between pin 7 and 12. It may be easier to find an aftermarket cable



    Thanks

  7. #7
    Join Date
    Feb 2003
    Location
    Hungary
    Posts
    15

    Hi ci.com!

    Yes I know this, it's ok.
    Don't worry about this just try what I said!!!
    Try to clean the pins with contact cleaning spray and with
    toot-brash!
    If not work I'll send to you another ericsson softwares.

    Best Regards

    Luises

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •