No network/signal

[jules]

Hi
just flashed 5130 with rollis 4.77
used Eeprom 3.1
but now I dont get network.signal ?????
I have not got a mbus cable so would it be possible to put a bit of tape over one of the fbus connecters to use my fbus as a mbus cable ?
thx jules

[glenborj]

check for cable schematics and you can change it into mbus by joining other wires to the appropriate pins. Try updating the FAID but then 5130 is in different bandwidht so signal is impossible if your country uses 900mhz, unless you replace the diplexer of the antenna to the appropriate bandwidht. It is done manually